Stitchtile

Bead pattern maker

Turn a photo into a fuse-bead (melty bead) pattern. Set the size in beads and the pegboard size, and get the pattern with board outlines, a colour key with bead counts and the number of boards.

Planning a bead project

What are fuse beads?

Fuse beads (also called melty, ironing or Perler-style beads) are short plastic tubes placed on a pegboard and fused with an iron. Standard “midi” beads are about 5 mm wide, so a design is about 5 mm × beads wide: 29 beads make about 14.5 cm (5.7 in). Mini beads are about 2.5–2.6 mm and halve the size.

Ironing the design

  1. Place the beads on the pegboard following the printed pattern; the bold lines show where one board ends.
  2. Cover them with ironing paper, set the iron to medium without steam and move it in slow circles for 10–20 seconds until the beads fuse.
  3. Let it cool under a heavy book so it stays flat, then lift it off, turn it over and iron the back if you want both sides fused.

Children should iron with an adult.

The same tool makes cross stitch charts and pixel art.

Questions

Does it match bead brand colours?
Not automatically: we show each colour with a hex code; pick the nearest bead colour from your brand’s range.
How many beads are in a 29 × 29 board?
841 when the board is full.
How do I make a design bigger than one board?
Set the width in beads above 29: the pattern is split into boards, outlined in bold, and the info line shows how many boards you need. Clip the boards together or lay them side by side.
Should I use dithering for beads?
Usually not. Dithering scatters single beads of different colours, which look noisy at bead size; flat areas of colour read better.